Make sure you keep track of halves you cut because you will reconnect them later. The easiest thing is to cut them anywhere in between where they're connected to the board and the lamp. There are 3 copper connectors (hard to see in photo). But it is useful to be good at soldering and desoldering.ฤก. I used the circuitry already built in and simply extended the contacts using wire. You do not need any knowledge of electronics for this project. NOTE: Capacitor is very dangerous, make sure you discharge it by bridging the two leads while grounded with an insulated screwdriver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |